top of page

TROUBLESHOOTING TIPS FROM JOEY SERVICES, HOME OF THE BBQ DOCTOR

Save time, money and frustration with the help of Joey Services. Please use the following troubleshooting tips to get the most out of your barbecue. The tips below are provided by Napoleon®, one of our leading suppliers. If you have questions or need more information, please call or check out our FAQ.

flame

PROBLEM: LOW HEAT/LOW FLAME WHEN THE VALVE IS TURNED TO HIGH

Possible causes

  • For propane, improper lighting procedure

  • For natural gas, undersized supply line

  • For both gases, improper preheating

Solution - Ensure the lighting procedure is followed carefully. All gas BBQ valves must be in the off position when the tank valve is turned on. Turn the tank on slowly to allow pressure to equalize. See lighting instructions. Disconnect and reconnect the regulator to the tank to reset regulator if a low flame or low heat has occurred. The pipe must be sized according to the installation code. Preheat the BBQ with both main burners on high for 10 to 15 minutes.

lowheatlowflame
grill

PROBLEM: EXCESSIVE FLARE-UPS / UNEVEN HEAT

Possible causes

  • Sear plates installed incorrectly

  • Improper preheating

  • Excessive grease and ash build on sear plates and in a drip pan

Solution - Ensure sear plates are installed with the holes toward the front and the slots on the bottom. See assembly instructions. Preheat BBQ with both main burners on high for 10 to 15 minutes. Clean sear plates and drip pan regularly. Do not line the pan with aluminum foil. Refer to cleaning instructions.

excessiveflareupsunevenheat
gas

PROBLEM: BURNERS BURN WITH A YELLOW FLAME, ACCOMPANIED BY THE SMELL OF GAS

Possible causes

  • Possible spider web or other debris

  • Improper air shutter adjustment

Solution – Thoroughly clean burner by removing. See general maintenance instructions. Open air shutter slightly according to combustion air adjustment instructions. This must be done by a qualified gas installer.

burner

PROBLEM: FLAMES LIFT AWAY FROM THE BURNER, ACCOMPANIED BY THE SMELL OF GAS AND POSSIBLE DIFFICULTIES IN LIGHTING

Possible causes

  • Improper air shutter adjustment

Solution – Close air shutter slightly according to combustion air adjustment instructions. This must be done by a qualified gas installer.

burnersburnwithayellowflame
flamesliftawayfromtheburner
ignitor

PROBLEM: BURNER WILL NOT LIGHT WITH THE IGNITER BUT WILL LIGHT WITH A MATCH

Possible causes

  • Dead battery or installed incorrectly

  • Loose electrode wire or switch terminal wires

  • Wrong replacement igniter

Solution – Replace with a heavy duty battery. Check that the electrode wire is firmly pushed onto the terminal on the back of the igniter. Check that the lead wires from the module to the ignition switch (if equipped) are firmly pushed onto their respective terminals. One spark systems must use a one spark igniter. Ensure that the collector box is tight and the gap between the electrode end and the collector box is between 1/8” to 3/16” (3mm-5mm). The gap can be adjusted by bending the box in or out. Close air shutter slightly (see the previous problem).

burnerwillnotlight
bottom of page